Panasonic AJSDX900P - 24P DVCPRO 50, Руководство по обслуживанию

Страница: 84 / 421

MECH-43
2-14. Mode SW Unit Replacement
(Removal)
1. Disconnect the connector (A) on the P.C.Board
(A) . (Please refer item “7. Table of Connector”
about reference number of connector and name
of P.C.Board.)
Click this mark , then go to item “7. Table of
Connector”.
2. Remove the Pinch Solenoid Unit and Loading
Motor Unit. (Refer to item 2-10 and 2-13.)
3. Remove the screw (E) and remove the Mode
Select Switch Unit from Loading Motor Unit as
shown in Figure 2-14.
(Installation)
1. Install the New Mode Select Switch Unit following
the removal steps in reverse order (Refer to item
“2-13. Loading Motor Unit Replacement”).
Note: Pay attention to the pin of Mode Switch Unit
which should be match with groove of Main
Cam Gear.
2. After install the Pinch Solenoid Unit, Pinch
Solenoid Position adjustment is required. (Refer
to item 2-11).
Figure 2-14
2-15. Main Cam Gear Replacement
(Removal)
1. Remove the Pinch Solenoid Unit and Loading
Motor Unit. (Refer to item 2-10 and 2-13.)
2. Remove the Main Cam Gear as shown in Figure
2-15.
(Installation)
1. Install the Main Cam Gear, then the pin of Main
Cam Arm Unit (
∗
) should match with the groove
position of Main Cam Gear as shown in Figure
2-15.
2. Follow the removal steps in reverse order.
3. After installation, perform the Pinch Solenoid
Position Adjustment. (Refer to item 2-11)
Figure 2-15