Panasonic AJ-PX5000G, Руководство по эксплуатации

Страница: 177 / 260

– 177 –
Chapter 7 Menu Operations — Menu list
Item Description of settings
[SDI EDH] Sets whether to add an error detection flag to SD SDI output.
[ON], [OFF]
f
Factory setting: [ON]
[HDSDI REMOTE] Sets whether to use the control function of recording operation for an external device (such as a recorder)
connected to the <SDI OUT1> terminal or <SDI OUT2> terminal. (At HD SDI output)
[ON], [OFF]
f
Factory setting: [OFF]
Selecting [ON] outputs recording operation control to an external device. While recording is instructed, the
red tally lamp, front tally lamp, back tally lamp of the viewfinder of the camera, and the rear tally lamp of
the camera illuminate. The display method for the recording status of the camera can be selected from the
main menu → [REC/PB] → [REC/PB SETUP] → [REC TALLY].
Recording operation control is not output in interval recording, one-shot recording, and loop recording.
Recording operation control is not output when 4G/LTE is set.
For the information on the supported external devices (such as recorders), visit the following website:
http://panasonic.biz/sav/autorec_e/
[THUMBNAIL OUT] Selects whether to output the thumbnail of a clip displayed on the LCD monitor to the <SDI OUT1>
terminal, <SDI OUT2> terminal, <HDMI OUT> terminal, and <VIDEO OUT> terminal.
[ON]: Performs output.
[OFF]: Does not output.
f
Factory setting: [OFF]
[SDI OUT1 MARKER]
Item Description of settings
[MARKER SW] Switches the marker.
[ON]: Displays.
[OFF]: Does not display.
f
Factory setting: [OFF]
[CENTER MARK] Switches the center marker.
[1]: + (large)
[2]: Open center (large)
[3]: + (small)
[4]: Open center (small)
[OFF]: Does not display.
f
Factory setting: [1]
[SAFETY MARK] Selects the type of frame for the safety zone marker.
[1]: Box
[2]: Corners
[OFF]: Does not display.
f
Factory setting: [2]
[SAFETY AREA] Sets the size of the safety zone marker.
The constant ratio of length to width can be set in 1% increments.
[80%]…[100%]
f
Factory setting: [90%]
[FRAME MARK] Enables/disables frame marker.
[ON], [OFF]
f
Factory setting: [OFF]
[FRAME SIG] Sets frame marker aspect ratio.
[4:3], [13:9], [14:9], [VISTA], [CNSCO]
f
Factory setting: [4:3]
[VISTA] is 16:8.65, and [CNSCO] is 16:6.81.
[USER BOX] Sets whether to display the user box to the signal from the <SDI OUT1> terminal.
[ON], [OFF]
f
Factory setting: [OFF]
[USER BOX WIDTH] Sets the width of the user box.
[1]…[100]
f
Factory setting: [13]
[USER BOX HEIGHT] Sets the height of the user box.
[1]…[100]
f
Factory setting: [13]
[USER BOX H POS] Sets the horizontal position of the center of the user box.
[ − 50]…[50]
f
Factory setting: [0]
[USER BOX V POS] Sets the vertical position of the center of the user box.
[ − 50]…[50]
f
Factory setting: [0]
[MONI OUT MARKER]