38
39
d) Select the cutting/chopping mode on the control
panel if this has not yet been preselected. The
overpressure function is preset as the standard
default for cutting/chopping prior to each start
but can be deactivated as required by pressing
the “Normal pressure” button before starting the
processing cycle.
When the START button has been pressed, the PACOJET 2 will proceed
through the chosen processing cycle fully automatically. Upon completion of
the processing cycle, the shaft and the 2- or 4-blade cutter attachment re-
turn to the start position, the beaker is depressurized automatically and the
processing cycle ends.
IMPORTANT!
Î
Never start the machine without having inserted a pacotizing beaker into
e)
the protective outer beaker!
After the cutting/chopping procedure
6.3.2
Demount the protective outer beaker containing the pacotizing beaker ac-
a)
cording to the PACOJET 2 instruction manual, section 6.2.4 with the spray
guard resting in place.
Remove the spray guard with the blade cutter attachment off the pactotiz-
b)
ing beaker using the three tabs.
Using the blade tongs, grasp the blade cutter attachment and remove it
c)
from the spray guard. The blade cutter attachment may now be cleaned
immediately under running water. Further cleaning directions can be found
in the separate instruction manual supplied with the Pacojet Coupe Set,
which is available as an optional add-on.
d) Should no further beakers be immediately proc-
essed, a rinsing cycle of the PACOJET 2 food
processing system must be consequently initiat
-
ed using the cleaning kit provided. Please clean
the machine in accordance with the instructions
found in Chapter 7.
Cutting/Chopping procedure
6.3.1
a) Fill the pacotizing beaker with small pieces of
fresh, non-frozen food, then add other desired
ingredients and seasonings.
IMPORTANT!
Î
Never fill the pacotizing beaker above the maximum fill-line. Overfilling beak
-
ers can result in extensive contaminant ingress that can lead to defects and
damage.
b) Remove the 2-blade or 4-blade cutter attachment from the packaging of
the Pacojet Coupe Set by holding only the upper/connector shaft part of
the blade cutter attachment. Next, use the blade cutter affixing tongs in
-
cluded to clasp the centre of the blade. The connector shaft part of the
blade cutter will face upward.
Install the spray guard on the cutter blade so that the cutter blade upper/
connector shaft goes through the hole in the spray guard. Using the cutter
tongs, bring the cutter blade and the spray guard up to the splined end of
the machine shaft. Check that the cutter blade and the spray guard are
affixed properly by exerting light upward pressure.
Now the pacotizing beaker and the protective beaker can be mounted onto
c)
the machine as described in section 6.2.3b of the PACOJET 2 instruction
manual.
