Door Installation/Removal
Figure 18: Glass door and hooks.
Removal
1. Remove the surround and backing plate from the front of the fireplace, “Surround Installation/Removal
Instructions” on page 41. Take care to disconnect the wire on the left hand side of the backing plate
which attaches the switch to the interior of the fireplace.
2. There are two handles located on the fireplace door (Figure 18) which must be pulled inward toward
the center of the fireplace to unlock the door (Figure 19). This may take some effort because the door
completes a tight seal around the firebox.
3. Remove the door and set aside.
Installation
1. Place the door over the opening of the fireplace.
2. There are two hooks on the top of the handles and two hooks on the bottom of the handle and so the door
must be placed squarely over the firebox opening.
3. Once the glass door is seated, close the door handles outward and inward until they stop.
4. The handle will not close completely. There will be an approximately 3/4” gap between the handles
and the door frame (Figure 20). This is normal.
5. Return the backing plate to its original position making sure to reconnect the switch wire to the backing
plate. Return the surround to its original position.
Figure 19: Unlocking the glass door.
Approx. 3/4”
gap
Figure 20: Door handles in closed position.
Figure 21: Locking the glass door.
15
100000300 051119-48
i40 TOFINO
