76
6.
From the controller board, connect the 4-pin connector to the charge board.
7.
Insert the controller back to the enclosure.
Replacing the Flash Backup Module (FBM)
You can install two FBM’s in the controller. Both FBM’s are located under host board 1.
NOTE:
Refer to section
Replacing the Host Board
when replacing/uninstalling a host board.
To replace the FBM:
1.
Shut your system down, unplug the power cords, then remove the controller. Wait for a
minute for the remaining electric current to dissipate.
NOTE:
See section
Replacing the Controller Module
for details.
2.
Loosen the screw that secures the FBM to the controller (A), lift it up to a 45
o
angle (B),
then remove it from the board.
