OutBack Power SmartRE 2500, Руководство по установке

Страница: 23 / 70

Installation
900-0033-01-00 Rev A
21
Mounting
The SmartRE is designed to be either free-standing or wall-mounted, indoors or outdoors. Choose
the method of mounting based on the weight of each enclosure and the available space at the
installation site.
¾
Wall-mounted. The SmartRE can be secured to a wall using the chassis and wall-mounting brackets
provided with each enclosure. The wall-bracket should be attached to the wall studs as wallboard is not
strong enough to support either enclosure. The wall-mounting bracket included is designed for wall studs
16” apart. If the wall studs are 24” apart, a longer wall-mounting bracket is available for purchase.
IMPORTANT:
The wall must be strong enough to support three (3) times the weight of the
enclosure. This may require additional support for the intended location. A
3/4” piece of plywood secured to the wall should provide the extra support
needed. Check local code for more specific requirements.
¾
Free-standing. The SmartRE can be mounted on a concrete pad (outdoor) or concrete floor (indoor). The
location should be level and able to support the full weight of the enclosures. Holes on the bottom on the
closure are provided to secure the enclosure to the mounting pad with 3/8” anchor bolts.
IMPORTANT:
For Outdoor Installations : If the mounting brackets are not being used, then as a
minimum, install the bolts (provided) for 3R compliance.
Figure 9 Mounting Options (Wall Brackets or Anchor Bolts)
If used
Use the dimensions in the Bottom View to drill
holes in floor or concrete pad for 3/8”
anchor bolts.
Use the dimensions in the
Back View to place
the wall-mounting bracket at the proper height
to match up with the chassis bracket.