Otto Bock 480S26 20000 K, Инструкция по эксплуатации

Страница: 35 / 40

All components of the product must be disposed of properly in accordance with the respective national environ­
mental regulations.
11.2 Information on re-use
CAUTION
Used seat padding
Functional and/or hygienic risks due to re-use
► Replace the seat padding if the wheelchair is to be re-used.
The product is generally suitable for re-use. However, please note that the product with its permanently welded
dimensions was tailored to one individual.
Similar to second-hand machines or vehicles, products that are being re-used are subject to increased strain. Fea­
tures and functions must not change in a way that could endanger users or other persons during re-use.
The product must first be thoroughly cleaned and disinfected before it can be re-used. Then the product must be
examined by an authorised specialist to check the condition and to look for wear and possible damage. All worn
and damaged parts as well as components which do not fit or are unsuitable for the new user must be replaced.
Detailed information on replacing components as well as information on the required tools and the prescribed ser­
vice intervals can be found in the service manual.
12 Legal information
All legal conditions are subject to the respective national laws of the country of use and may vary accordingly.
12.1 Liability
The manufacturer will only assume liability if the product is used in accordance with the descriptions and instruc­
tions provided in this document. The manufacturer will not assume liability for damage caused by disregarding the
information in this document, particularly due to improper use or unauthorised modification of the product.
12.2 Warranty
Further information on the warranty terms and conditions can be obtained from the qualified personnel that has fit­
ted this product or the manufacturer's service (see inside back cover for addresses).
12.3 Lifetime
Expected lifetime: 4 years
The design, manufacturing and requirements for the intended use of the product are based on the expected life­
time. These also include the requirements for maintenance, ensuring effectiveness and the safety of the product.
13 Technical data
INFORMATION
All information in the following tables refers to the respective custom-made model. The dimensional tolerance is
+/-15 mm, +/-2°.
Dimensions
Frame length Custom fabrication
Lower leg length [mm] Custom fabrication
Minimum frame length [mm] Custom fabrication
Minimum rear seat height [mm] 330
Maximum front/rear seat height [mm] Custom fabrication
Width
1)
Overall width = seat width + 20 mm per degree of
wheel camber
Overall height Custom size
Back height [mm] from 220
Armrest height Custom size
Length with footrest Custom size
Length without footrest Custom size
Seat cushion thickness [mm] 30; 50; 60; 90
35 Invader 480S26=20000_K
Legal information