ORTEC DSPEC Pro, Руководство пользователя по оборудованию

Страница: 33 / 108

794380D / 0914 2. GETTING STARTED
23
Figure 12. Change MCB Number or Description.
Make the desired changes and click Close. Any changes you have made to an ID number or
description will then be written back to the corresponding MCB.
If a modified description has already been applied to a particular instrument, you can restore the
default description by deleting the entry in the Description field and re-running MCB Config-
uration. After MCB Configuration runs, the default description will be displayed.
2.2.5. Attaching More Than One DSPEC Pro to the Computer
Once the drivers have been installed for one DSPEC Pro, adding subsequent units is simple.
REMINDER
Be sure to run MCB Configuration any time you add new DSPEC Pros (or other
ORTEC MCBs) to your system, or when you move an instrument from one USB
port to another.
NOTE FOR MULTIPLE USERS ON A NETWORK
There are two ways to reduce the chance that other users will renumber your MCBs:
!
Add the
-I
flag to their MCB Configuration command line, as described in the C
ONNEC
-
TIONS
Driver Update Kit instructions. This will allow you to assign whatever ID Numbers
you wish, regardless of the numbers assigned by other users on your network. (Ideally,
everyone using ORTEC instruments on your network should make this change.)
!
To prevent others from renumbering your MCBs (or performing any other actions except
read-only viewing), password-lock your MCBs with the MAESTRO Lock/Unlock Detector
command. If you lock a detector that will be controlled by a JOB stream, remember to
include the proper password-unlock commands in your
.JOB
file (see the MAESTRO user
manual).