ORTEC DSPEC Pro, Руководство пользователя по оборудованию

Страница: 67 / 108

794380D / 0914 4. FIRMWARE COMMANDS AND RESPONSES
57
DISABLE_ETP
Returns the DSPEC Pro to normal operation if in Enhanced Throughput (ETP) mode. See
also ENABLE_ETP, SHOW_ETP, SET_TIME_ETP, LIST_TIME_ETP, and
SHOW_TIME_ETP.
DISABLE_GAIN_STABILIZATION
Stops stabilization of the gain peak while data is being acquired. The gain stabilization
adjustment is held at its current value until either gain stabilization is reenabled with the
ENABLE_GAIN_STABILIZATION command or reinitialized with the INITIALIZE_
GAIN_STABILIZATION, SET_GAIN_PEAK or SET_GAIN_WIDTH command. See also
SHOW_GAIN_STABILIZATION.
DISABLE_GATE_ROUTE
No function in the DSPEC Pro; included for backward compatibility.
DISABLE_HV
Turns off the high-voltage enable signal of the DSPEC Pro. See the section on the bias
supply for more information about the high-voltage output. See also ENABLE_HV and
SHOW_HV.
DISABLE_HV_DIM
Disables the use of the MCB connector on the back of the DSPEC Pro and causes the
DSPEC Pro to suppress State of Health information (see SHOW_HV_HEALTH command).
Also, the command disables polling of a standard DIM module (e.g. DIM-POSNAI,
DIM-POSGE, DIM-NEGGE, or DIM-296) by the DSPEC Pro.
DISABLE_LFR
Returns the DSPEC Pro to normal operation if the LFR filter is enabled. See also ENABLE_
LFR and SHOW_LFR.
DISABLE_NAI
Switches the stabilizers to Ge mode. See ENABLE_NAI.
DISABLE_OPTI_NEED
Disables the reporting of an error when the DSPEC Pro has not been optimized.
DISABLE_OVERFLOW_PRESET
Disables the overflow preset. Channels that receive a count when they contain 2147483647
counts, the maximum number of counts, will roll over to zero counts if the overflow preset is
disabled. See also ENABLE_OVERFLOW_PRESET and SHOW_OVERFLOW_PRESET.