OSHD-410H & OSHD-810 & OSHD-1610
Install & User Manual - Firmware 3.X 32
Select channel to copy.
Default value is Set All.
3.5.2. Sensor Setting
MENU
EVENT
SENSOR
3.5.2.1.
All Sensor
It is used when setting for all sensors and set
“Off”, or Normal Open
(N.O.) / Normal Close (N.C.) type.
1) Select
“All” and Type then press [ESC] to confirm setting.
3.5.2.2.
Each Sensor
It is used when setting for each sensor and set selecting each sensor.
1) Select Sensor to be set by user, select type then press [ESC] to
confirm setting.
3.5.3. Relay Setting
MENU
EVENT
EVENT
It is available to run relay selecting from sensor, motion detection,
Text, Video Loss which is normal event source and Disk error, Disk
full, Fan error, authentication fail, WRS registration fail, Mirroring fail,
abnormal Recording stop which is system event source. Also, user
can set working condition by schedule. In case of using control center
thru. Network, relay could be run from remotely
3.5.4. Serial Setting
MENU
DEVICE
SERIAL
[Serial Port] [PTZ Port]
From serial setting, you can set protocol, port, baud rate, parity bit, stop bit and data bit.
After completed serial setting, select desired channel from camera menu, and setting up PTZ Home, PTZ Idle
Time, PTZ Port, and PTZ address.
3.5.4.1.
Serial (COM1) Setting
