Orion BuckEye Cam RC-5030, Руководство пользователя

Страница: 46 / 62

44 8. Repeater Function Description
In an example illustrated blow, Camera 1 needs to be set to transmit
pictures through Camera 3. All the user has to do is to change routing
configuration on Camera 1:
1. Press MENU button
2. Using UP / DOWN buttons scroll until you see
ROUTE
on the
display
3. Press SELECT button
4. Using UP / DOWN buttons select the camera that will retransmit
pictures to the PCBase. For the given example select C-03 . This
will tell the camera “to transmit pictures to Camera 3 and camera
3 will repeat them to the base”.
5. Press SELECT button. This will change the routing path for the
camera.
NOTE: Because the camera is not “aware” of what other cameras are
registered to the PCBase, any camera number from
C-01
to
C-30
can
be selected. The user has to make sure that the camera number selected
is registered in the PCBase.
After the routing path is changed on the camera, it is recommended that the
user check the signal strength using the signal button. If a camera is set to
route to another camera (not the base), pressing the
SIGNAL button on
that camera will initiate the signal measurement to the next camera down
the path to the base. In the example above, the reported signal strength on
Camera 1 will be how well Camera 3 can hear Camera 1.
On the other hand, if the signal for Camera 1 is measured from the base,
the strength reported will be the how well Camera 1 can hear Camera 3.
There is no set limit to how long the chain can be. However, the user
should keep in mind the longer the chain on repeating cameras, the slower
the transmission speed is going to be. User should also make sure that there
are no routing loops created, where Camera 3 transmits pictures to Camera
2, Camera 2 transmits pictures to Camera 1, and Camera 1 transmits
ORION - Owner's Manual, Rev. 3.6
Remote
Camera 1
PCBase
Remote
Camera 2
Remote
Camera 3