Oracle netra X5-2, Руководство по установке

Страница: 45 / 152

Port Description You Need:
SER MGT (COM1) Provides a TIA/EIA-232 serial
Oracle/Cisco standard
connection to the SP through
an RJ-45 connector.
SER MGT (COM1) connects
to either Service Processor by
default, but can be redirected
to the host.
Default settings:
• 8N1: eight data bits, no
parity, one stop bit
• 9600 baud (change to
115200 baud)
• Disable hardware flow
control (CTS/RTS)
• Disable software flow
control (XON/XOFF)
A terminal device (For
example, terminal, connection
to a terminal server, or
computer such as a laptop
running terminal emulation
software)
A cable to connect the
terminal device to the SER
MGT (COM1) port
USB Provides USB3.0 connection
to the computer. You can
connect and disconnect USB
cables to the USB port without
affecting server operations. Installation media
Note: Maximum USB cable
length: 5 meters
Cable the Oracle X8-2
After mounting the Oracle X8-2 in an equipment rack and installing all components, use the
following instructions to connect all appropriate data cables to the ports before powering the
system up and beginning the configuration.
Oracle qualified the following configurations of the Oracle X8-2.
• Configuration A: One Four-port 10 GigE NIC
• Configuration B: Two Four-port 10 GigE NICs (each of the three slots are qualified)
• Configuration C: One QSFP NIC (in quad port mode only) and ONE Four-port 10 GigE
NIC
Note:
The X8-2 does not support the 40G interface speed.
On board interfaces for all configurations include:
• One RJ-45 serial management (SER MGT) port
• One 10/100/1000BASE-T RJ-45 Oracle Integrated Lights Out Manager (ILOM) service
processor (SP) network management (NET MGT) port
• One 1000BASE-T RJ-45 Gigabit Ethernet (GbE) port, labeled NET 0
• Two 10/25GbE SFP+ Ethernet ports, labeled NET 1 and NET 2
• Two 10GBASE-T RJ-45 Gigabit Ethernet (GbE) ports, labeled NET 1 and NET 2
Chapter 4
Cable the Oracle X8-2
4-9