Oracle netra X5-2, Руководство по установке

Страница: 110 / 152

Change Boot Parameters from the ACLI
To access and change boot parameters from the ACLI:
1.
In Superuser mode, type configure terminal, and press Enter.
ORACLE# configure terminal
2.
Type bootparam, and press Enter. The boot device parameters display.
ORACLE(configure)# bootparam
'.' = clear field; '-' = go to previous field; q = quit
Boot File : /boot/nnScz100.bz
To navigate through the boot parameters, press Enter and the next parameter appears on
the following line.
You can navigate through the entire list this way. To go back to a previous line, type a
hyphen (-) and press Enter. Any value that you enter entirely overwrites the existing value
and does not append to it.
3.
To change a boot parameter, type the new value that you want to use next to the old
value. For example, if you want to change the image you are using, type the new
filename next to the old one. You can clear the contents of a parameter by typing a period
and then pressing Enter.
ORACLE(configure)# bootparam
'.' = clear field; '-' = go to previous field; q = quit
Boot File : /boot/nnSCz100.bz /boot/nnSCz200.bz
When you have scrolled through all of the boot parameters, the system prompt for the
configure terminal branch displays.
NOTE: These changed parameters will not go into effect until reboot.
Also, be aware that some boot parameters may also be changed through
PHY and Network Interface Configurations.
ORACLE(configure)#
4.
Exit the configure terminal branch.
5.
Reboot the system for the changes to take effect.
The ACLI reboot and reboot force commands initiate a reboot. With the reboot
command, you must confirm that you want to reboot. With the reboot force command,
you do not have make this confirmation.
ORACLE# reboot force
The system completes the full booting sequence. If necessary, you can stop the auto-
boot at countdown to fix any boot parameters.
Chapter 8
Changing Boot Parameters
8-5