12"-16"
½"
1.3cm
31-41cm
Step 6: Mount CabLED™
32
cabled.optiled.com
6.2 Use One of the Following Five Methods to Mount CabLED™
6.1 Mark Placement for Brackets
When installing the CabLED strip, select one of the six IP65 mounting solutions designed to be
used with the 8000 Series for either indoors or outdoors. Plan on using a bracket next to each
connector on the end of each strip in each section and then spaced evenly between 12 to 16
inches (31-41cm) apart. Allow a half inch to clear each connector.
Install Angle Channeling
Angle Channeling fits into the corner of two surfaces and directs the light at a 30 degree angle.
You may install it so the light points up or down. The example shows the light pointing down.
into
bottom
slide
into
lip
snap
A
Determine the desired direction of the light
and hold Angle Channeling against surface.
Secure with screw every 12 to 16 inches (31-
41cm). Or apply double sided tape on the
bottom of the Angle Channeling.
B
Slide CabLED at an angle into the longer side of
the Angle Channelling, and then push down to
snap strip into place.
