slide until
all ridges are covered
look for ridges
on
each
side
of strip
Step 4: Install Connectors
26
cabled.optiled.com
C
Using pliers, apply even pressure to the bottom and top halves of each
connector to push them together, securing the CabLED strips inside.
Connects two CabLED strips at a 90 degree angle to form a corner.
4.5 Install L-Connector
IMPORTANT: The connectors consist of two parts, a top and bottom, which are
partially assembled at the factory. DO NOT push the connectors together before you
are ready to install.
!
A
Remove the protective piece from
L-Connector. With the LED side of each strip
facing up, insert one strip into one side of the
L-Connector and push it to the end. Insert the
other strip into the other side and push it to
the end.
B
Push both strips completely into the
connector. The ridges on each side of the
strip will be covered when the strip is properly
installed.
IMPORTANT: When using pliers that do not cover the entire surface of the connector, hold the
connector and strip steady so the CabLED strip remains in position. Carefully rotate the pliers and apply
pressure to each side of the connector, pushing the top and bottom together.
!
D
Make sure both sides of the bottom half of the connector snap into
the top half. Gently pull the CabLED strips to make sure you have
installed them properly.
