snap
into
lip
snap
into
lip
slide
into
top
snap
in
place
Step 6: Mount CabLED™
36
cabled.optiled.com
NOTE: Installation shown at 0 degree angle.
C
Push the stakes firmly into the ground spaced
from 12 to 16 inches (31-41cm) apart.
D
Fit each mounting clip into the stake at the
desired angle.
A
First install the CabLED into the Channeling
by sliding the strip straight into top of
Channeling, and then push down to snap
strip firmly and smoothly into Channeling.
B
Install Channeling into upper cavity of
mounting clip. Slide in at an angle with high
lip into tall side of mounting clip until it sits on
ledge and then snap other end into place.
Repeat to install the mounting clips spaced the
same distance you are installing the stands,
between 12 to 16 inches (31-41cm) apart.
Adjust Channeling if LEDs are blocked by the
stand.
Install Garden Stake With Channeling
The Garden Stake consists of two pieces, the mounting clip and the stand, which are assembled
to angle the direction of the light between 0 and 135 degrees at 11.25 degree intervals.
The mounting clip, is designed with two cavities. Install the CabLED strip alone in the bottom or
the CabLED strip with the Channeling into the top. Follow the instructions for each method for
the easiest installation
Angle marked on
outside stand
IMPORTANT: Use Garden Stakes where CabLED will be installed on the ground
outside. Install so CabLED or connectors will NOT be submerged in water.
!
