slide until
all ridges are covered
look for ridges
on
each
side
of strip
Step 4: Install Connectors
cabled.optiled.com
27
B
Push the strips completely into the connector.
The ridges on each side of the strips will be
covered when the strip is properly installed.
D
Make sure both sides of the bottom half of the connector snap into
the top half. Gently pull the CabLED strips to make sure you have
installed them properly.
4.6 Install T-Connector
Connects three CabLED strips in a flexible T shape.
C
Using pliers, apply even pressure to the bottom and top halves of each
connector to push them together, securing the CabLED strips inside.
A
Remove the protective piece from each side
of the T-Connector. With LED side facing
up, slide one CabLED strip into the opening
in bottom half of one side of the connector
until it reaches the end. Repeat with the
other CabLED strips in the other sides of the
connector.
IMPORTANT: The connectors consist of two parts, a top and bottom, which are
partially assembled at the factory. DO NOT push the connectors together before you
are ready to install.
!
IMPORTANT: When using pliers that do not cover the entire surface of the connector, hold
the connector and strip steady so the CabLED strip remains in position. Carefully rotate the
pliers and apply pressure to each side of the connector, pushing the top and bottom together.
!
