Opticon LG2 Series, Руководство пользователя

Страница: 17 / 113

LG2 User’s Manual 25-ULG2MU01-02 - 8
Save Settings
LG2 User’s Manual 25-ULG2MU01-02 - 9
Save Settings
To connect the LG2 to your host computer via RS-232 interface:
1.
Make sure the RS-232 cable is sufficiently attached to
your LG2 unit (figure 2.4).
2. Power off your host computer (figure 2.5).
3. Connect the RS-232 interface cable to your host
computer (figure 2.6). If you are unsure of the proper
location to connect the RS-232 cable please consult the manual of your host computer.
4. The RS-232 interface should have come with a power supply. Plug the power supply adapter into
the RS-232 interface cable (figure 2.7) and then plug the power adapter into a wall socket (figure
2.8). The RS-232 interface does not require additional power. However, if you are using the
RS-232 interface and utilizing Batch functionality, please read the Important Note in section 7.1.
If you are using the 1300 mA battery for batch mode, the LG2 will recharge the battery whenever
the unit is a attached to a RS-232 cable that is plugged into a wall socket.
5. Power up the host.
6. The LG2 will power on automatically.
7. Scan the following barcode to set the correct reader communication mode.
RS-232 One Way Mode
NOTE: All Baud Rate, Parity, Stop Bit and Data Bit settings can be found in Chapter 5.
8. Your LG2 unit should be ready for use. Open the application you wish to send data and begin
scanning.
2.2 - Installation Guide - RS-232 Interface
Figure 2.4 Figure 2.5
Figure 2.6
Figure 2.7
Figure 2.8
Default Settings
Baud Rate 57600
Stop Bits 1
Data Bits 8
Parity None