Opengear ACM5000, Руководство пользователя

Страница: 152 / 335

Chapter 7: Alerts and Logging
152
Console Server & RIM Gateway User Manual
7.2 Check Conditions
To configure the condition that will trigger the Auto-Response:

Click on the Check Condition type (e.g. Environmental , UPS Status or ICMP ping ) to be configured as the trigger
for this new Auto-Response in the Auto-Response Settings menu
7.2.1 Environmental
To configure Humidity or Temperature levels as the trigger event:

Click on the Environmental as the Check Condition

In the Environmental Check menu, select the specific Environmental Sensor to be checked for the trigger

Specify the Trigger value (in °C / °F for Temp and % for Humidity) that the check measurement must exceed or
drop below to trigger the AutoResponse

Select Comparison type as being Above Trigger Value or Below Trigger Value to trigger

Specify any Hysteresis factor that is to be applied to environmental measurements (e.g. if an Auto-Response
was set up with a trigger event of a temp reading above 49°C with a Hysteresis of 4 then the trigger condition
would not be seen as having been resolved till the temp reading was below 45°C)

Check Save Auto-Response