Opengear ACM5000, Руководство пользователя

Страница: 123 / 335

User Manual
Advanced Console Server & RIM Gateway User Manual
123

Enter the IP or DNS Address of the console server and the SSH port that will be used (typically 22)
Note If SDT Connector is connecting to a remote console server through the public Internet or routed network you will
need to:

Determine the public IP address of the console server (or of the router/ firewall that connects the console
server to the Internet) as assigned by the ISP. One way to find the public IP address is to access
http://checkip.dyndns.org/ or http://www.whatismyip.com/ from a computer on the same network as the
console server and note the reported IP address

Set port forwarding for TCP port 22 through any firewall/NAT/router that is located between SDT Connector
and the console server so it points to the console server . http://www.portforward.com has port forwarding
instructions for a range of routers. Also you can use the Open Port Check tool from
http://www.canyouseeme.org to check if port forwarding through local firewall/NAT/router devices has been
properly configured

Enter the Username and Password of a user on the gateway that has been enabled to connect via SSH and/or
create SSH port redirections

Optionally, enter a Descriptive Name to display instead of the IP or DNS address, and any Notes or a
Description of this gateway (such as its firmware version, site location or anything special about its network
configuration).

Click OK and an icon for the new gateway will now appear in the SDT Connector home page
Note For an SDT Connector user to access a console server (and then access specific hosts or serial devices
connected to that console server ), that user must first be setup on the console server , and must be authorized to
access the specific ports / hosts (refer Chapter 5) and only these permitted services will be forwarded through by
SSH to the Host. All other services (TCP/UDP ports) will be blocked.