6
1-2 Connecting the Devices
Preparation
1-2
Connecting the Devices
1-2-1
Connecting the Controller to the Power Supply
Use a power supply that meets the following specifications.
Important
Use a DC power supply with countermeasures against high voltages (safe
extra low-voltage circuits on the secondary side). If the system must meet UL
standards, use a UL class II power supply.
1.
Loosen the two screws on the top of
the Power connector (male) using a
flat-blade screwdriver.
2.
Insert the DC power terminal (wire)
into the Power connector (male) and
tighten the two screws on the top of
the Power connector to fasten the
power terminal with the screwdriver.
Tightening torque: 0.22 to 0.25 Nm.
3.
Plug the Power connector (male) into
the Controller’s Power connector (fe-
male).
4.
Tighten the two screws on the left and right of the Power connector (male)
with the screwdriver to fasten it. Tightening torque: 0.22 to 0.25 Nm.
1-2-2
Attaching Ferrite Cores
Attach ferrite cores (supplied) to both ends of the camera's cable and the
Controller's power cable, respectively.
Item
Specification
Power supply voltage
Approx. 24 VDC (21.6 to 26.4 VDC)
Output current
1.5 A min.
Recommended power supply
S8VS-06024 (24 VDC, 2.5 A)
Recommended electric wire size
0.14 to 1.5 mm² (max. 1 m)
24 VDC
-
+
Ferrite core
Ferrite core
+
-
Ferrite core
DC power
supply
When attaching ferrite cores to the
Controller's power cable, pass the
cable once through each ferrite core.
Z01E-EN-01+ZFX+SettingGuide.book Seite 6 Mittwoch, 13. Februar 2008 2:38 14