![background image](http://html1.mh-extra.com/html/omron/ns-cxdc1-v3/ns-cxdc1-v3_user-manual_744231066.webp)
44
Creating Screens Using Symbols
Section 4-1
Note
To use tags (network symbols), the same tags must be registered in both the
PT and the host. If tags are added or changed in either the CX-Designer or
CX-Programmer, copy them to the other one. Tags are supported by CX-Pro-
grammer 8.0 or higher.
Procedure
Copying CX-Programmer Symbols to the CX-Designer
1,2,3...
1.
Start CX-Programmer and open the project with the symbol to be shared.
2.
Select the symbol from the CX-Programmer symbol table.
3.
Open the CX-Designer symbol table and paste the symbol.
4.
If a host address is set for the symbol, select the applicable host for the
destination.
Copying CX-Designer Symbols to the CX-Programmer
1,2,3...
1.
Select the symbol from the CX-Designer symbol table and copy it to the
CX-Programmer.
2.
Open the CX-Programmer symbol table and paste the symbol.
The same symbol as the CX-Programmer
symbol is added.
CX-Programmer symbols are copied and
pasted to the CX-Designer symbol table.
The same symbol as the CX-Designer symbol is added.
Содержание NS-CXDC1-V3
