![background image](http://html1.mh-extra.com/html/omron/fz5-series/fz5-series_hardware-setup-manual_742694173.webp)
5 - 3
5 Setup and Wiring
Vision System FZ5 series Hardware Setup Manual (Z423)
5-1 Wh
en turnin
g ON an
d
OFF
5
5-
1-1
A
ll Series
5-1
When turning ON and OFF
Precautions for Safe Use
• Do the following confirmations again before turning on the power supply.
• Is the voltage and polarity of the power source set correctly? (24 VDC for positive terminal.
0 VDC for negative terminal.)
• Is not the load of the output signal short-circuited?
• Is the load current of the output signal appropriate?
• Is not the mistake found in wiring?
• Ground the Sensor Controller independently.
If sharing the ground line with other devices or connecting it with a building beam, the Sensor
Controller might be adversely effected.
• Always turn OFF the Sensor Controller's power before connecting or disconnecting a camera
or cable. Connecting the cable with power supplied may result in damage of the camera or
peripheral devices.
• Illumination is normal immediately after the power supply is turned ON. Do not look directly
into the illumination light.
• After confirming that this product is started up, communicate with the high-order device.
• Should you notice any abnormalities, immediately stop use, turn OFF the power supply, and
contact your OMRON representative.
Precautions for Correct Use
Turning OFF the Power
When a message is displayed indicating that a task is in progress, do not turn OFF the power.
Doing so causes the data in the memory to be corrupted, resulting in the product not operating
properly upon the next start-up.
Do not turn OFF during saving data to Sensor Controller.
When turns OFF, conform the followings proceedings have completed and then operate again.
• When saves using Sensor Controller:
Confirm the save processing is completed and next operation is possible.
• When saves using communication command:
Intended command is completed. BUSY signal is turned OFF.
5-1-1
All Series
Do not connect AC power source to Sensor Controller.
If connects AC power source, it might be a cause of the failure.
Do not touch the terminals while the power supply is ON.
Doing so may result in electrical shock.
Danger of burns. Do not touch the case while the LED is ON or just after power is turned OFF,
since it remains extremely hot.
WARNING
CAUTION
Содержание fz5 series
Страница 8: ...Manual Structure 6 Vision System FZ5 series Hardware Setup Manual Z423...
Страница 50: ...1 Confirm the Package 1 14 Vision System FZ5 series Hardware Setup Manual Z423...
Страница 162: ...3 Configuration 3 100 Vision System FZ5 series Hardware Setup Manual Z423...
Страница 285: ......