Omron CX-MOTION - 06-2008, Руководство по эксплуатации

Страница: 129 / 135

110
Error Codes Section 15-2
Command timeout 037Ah
-
0399h 300Ch 300Ch A MECHATROLINK command could not be completed within a
fixed period of time (10 seconds). The followings are the possible
causes:
• Disconnection, breakage of MECHATROLINK cable
Check the MECHATROLINK cable.
• Communications error caused by noise
Remove the cause of the noise.
When this error persists even after providing these remedies, the
Driver (NS115) or MC Unit may be broken. Replace the broken
one with a new unit.
Absolute encoder error 300Dh 300Dh Data from the ABS encoder could not be processed normally.
• Initial multi-turn value exceeds the multi-turn limit.
Set the same value in the driver parameter [Pn205: Multi-turn
limit setting] and the motor parameter [900C: Multi-turn limit].
After the setting is completed, restore the power, reset the alarm,
and perform the origin setting.
• After origin setting, the following values related to B/A were
changed.
Note B = No. of encoder pulses
×
P5AA05
A = P5AA04
×
P5AA06
B/A is integer calculation and the result is to be reduced.
After the change was made (saving to F-ROM), restore the
power, reset the alarm, and perform origin setting.
• The multi-turn limit value in the driver parameter or the motor
parameter was changed after origin setting.
After the change was made (saving to F-ROM), restore the
power, reset the alarm, and perform origin setting. (When the
multi-turn value of the driver parameter was changed, make sure
to perform “Absolute encoder multi-turn amount setting change”
on the driver.)
• Servo driver is set as an incremental encoder. Set the driver
parameter Pn002 digit No. 2 to “0” (used as an absolute encoder)
and restore the power.
• Disconnection, breakage of encoder cable
Check the encoder cable.
• Communications error caused by noise
Remove the cause of the noise.
When this error persists even after providing these remedies, the
encoder or MC Unit may be broken. Replace the broken one with
a new unit.
Name Error log Alarm
code
Cause and remedy
Error
code
Detail
code