Omron CRT1 - 10-2009, Руководство по эксплуатации

Страница: 335 / 675

311
Summary of the Analog Input Slave Units
Section 6-2
3. Select the tab of the channel for which you would like to change the range
and select any input range from the pull-down list of "Input Range".
4. Return to the General Tab Page, click the Transfer [PC to Unit] Button to
download the data, and then click the Reset Button to reset the Unit.
5. Click the OK Button and exit the window.
AD Conversion Data for
Negative Numbers If the AD conversion data is a negative number, it is expressed as the two's
complement. The NEG instruction (two’s complement conversion) can be
used to obtain the absolute value of the two’s complement.
6-2-2 Calculation and Selection Processing of Input Data
Input Data Calculation The following types of calculations can be performed in the unit for external
analog input values.
• Scaling to desired industry unit
• Moving average processing
After processing, the data can be allocated to the Master Unit I/O.
In addition, the following types of calculations can be performed for analog
values for which the processing described above was performed.
• Peak/hold operation
• Top/valley operation
• Rate of change operation
• Cumulated count operation
The values after these calculations are called "Peak Value", "Bottom Value",
"Top Value", "Valley Value", "Rate of Change", and "Cumulated Count Value".