Omron BL100T, Инструкция по эксплуатации, Страница: 8 / 83

Safety Precautions
BL50T/BL75T/BL100T
8
Caution
(For installation and connection)
When carrying the UPS, pay attention to its weight and balance, and
when using it, put it in a stable and robust place.
● There is a risk of injury if the product falls or drops.
● Weight:
BL50T: Approximately 5.2kg
BL75T: Approximately 5.8kg
BL100T: Approximately 6.4kg
● In a case of dropping the UPS, stop using the unit and immediately ask for the
inspection and repair.
For information about repair, contact Omron Electronics Repair Center.
● Be careful about crush injury when your fingers are in between the installation
surface and the bottom surface of the UPS.
Caution
(For installation and connection)
Keep the plastic package bags away from children.
● Avoid the risk of a child playing with it to suffocate.
Be sure to connect the "AC input" of the UPS to a rated input voltage
(100VAC) and frequency 50/60Hz commercial power supply.
● Connecting to a power outlet (commercial power supply) with a different voltage
and frequency may cause a fire.
● The UPS may fail.
In case of an abnormality (abnormal noise/odor), stop the output by
turning off the "Power" switch on the UPS and pull the "AC input" plug
from the power outlet.
Install the "AC input" plug in such a way that it can be immediately
pulled out from the power outlet.
● For safety, follow the above instructions when maintaining the connected
equipment as well.
Do not connect the half-wave rectifier where the current flows only in a
half cycle of AC power supply, such as dryer and some solenoid valves.
● Overcurrent may damage the Uninterruptible Power Supply.
Connect to the power outlet (commercial power supply) with the
following current capacity.
・ BL50T: 7.5A
・ BL75T: 12A
・ BL100T: 15A
● Power wiring can catch heat.
● When a device with the maximum output capacity is connected, the current flows
as follows.
・
BL50T: 7.5A
・
BL75T: 12A
・ BL100T: 15A