Omron BL100T, Инструкция по эксплуатации

Страница: 45 / 83

3 Check and start the operation
3-4Operation by using the LCD menu
BL50T/BL75T/BL100T
45
3
☆ : Displayed only when the UPS is stopped. Not displayed while the UPS is running.
Menu item Description Value
Menu Type
Settings Battery Settings
Low Battery Warning ☆
Set the level at which a low battery warning
can be detected.
Low battery warning:
Initial setting (factory default), Level
change: 0 to 100%
Advanced
Dry Contact BMS setting (Note 3) Temporarily stop communication between
the CPU in the battery pack (BMS) and the
CPU in the CPU when replacing the
battery.
BMS mode enabled/disabled
(Factory default) Enabled
BSsignal
ValidRange ☆
Set the condition for BS signal reception. BS signal valid range:
Always enabled (factory default),
Only for backup operation
BSsignal
Delay Time
Set the delay time for a BS signal. BS signal delay time:
0 to 9000 seconds, or 9999 seconds
(Factory default: 0 second)
BUsignal
Delay Time
Set the delay time for a BU signal. BU signal delay time:
0 to 180 seconds
(Factory default: 0 second)
Dry Contact Logic Set the dry contact logic. Dry Contact logic:
BU, BL, TR, WB:
Normal (factory default)/
Reverse
Remote ON/OFF
Logic ☆
Set the remote signal logic.
This setting is common to a contact signal
I/O card and remote ON/OFF dedicated
connector.
Remote ON/OFF logic:
OFF when short-circuited (factory default),
OFF when opened, Disabled
Identification
Type Display the names of the UPS and battery
pack.
Type name:
UPS: Model.
Battery: Model
Standard
Serial Number Display the serial number of the UPS. Serial number:
S/N: xxxxxxxxxxxxxxxG
Firmware Version Display the firmware version of the UPS. Firmware version:
UPS: M:x.xx
USB: S:x.xx
Advanced
Memorandum Information up to 20 alphanumeric
characters can be viewed.
-
Log Fault Log Display up to 10 logs of faults that occurred
in the past (time of occurrence and fault
details).
Fault log:
Year/month/day/hour/minute, message
Standard
Shutdown Log Display up to 10 reasons for UPS
shutdown.
Shutdown log:
Year/month/day/hour/minute, message
AC input Log Display up to 10 logs of events that
occurred in the past.
AC input log:
Year/month/day/hour/minute, message
Reset All Log Data Clear each piece of log data. Execute Reset All Log Data
Note 1: Refer to "9-4 Input voltage sensitivity settings".
Note 2: Refer to "9-3 Battery life".
Note 3: BMS stands for Battery Management System.
A lead battery UPS does not require the BMS.
A lithium battery UPS always are safely managed a battery condition using the
BMS.