Omron BL100T, Инструкция по эксплуатации

Страница: 33 / 83

3 Check and start the operation
3-1Names and functions of parts in the operation and display sections
BL50T/BL75T/BL100T
33
3
■ Error other than a battery error
○: Lit ON ●: Lit OFF
UPS status Icon
LED
Buzzer Output Charge Message at
top
Description Solution
Overload
(Flashing)
○ ○ ○
Intermitte
nt, at
intervals
of 0.5
seconds
ON
ON or
discha
rging
Fault-E9
(Note 1)
The load
amount of the
connected
devices is
excessive.
Turn OFF all the Power switches
on the UPS and connected
devices, reduce connected
devices, and turn ON the "Power"
switches on the UPS and
remaining connected devices.
Note: You can check the load
amount by selecting the
"Measurement" menu - "Load
Amount".
○ ● ○
UPS end of
life
(Flashing)
○ ○ ○
Intermitte
nt, at
intervals
of 2
seconds
(Note 2)
-
UPS
end of life
The UPS
reached end
of life as a
product.
Replace the UPS.
○ ● ○
UPS failure
(Flashing)
● ● ○
Continuo
us
ON or
OFF
Depen
ding
on the
failure
conditi
ons
UPS failure A UPS failure
occurred.
Turn on only the power switch
again.
If the displayed content does not
change, the UPS is faulty. Contact
your dealer or OMRON Electronic
Equipment Customer Support
Center.
Bypass
mode
○ ● ●
Dependi
ng on the
failure
condition
s
ON
ON or
discha
rging By-pass
mode
Commercial
power is being
output as-is in
bypass mode.
Refer to the displayed message.
○
○
(Flashi
ng)
● OFF OFF Enable the BMS setting.
Note 1: During normal operation, the displayed message alternates between "Commercial operation mode" and
"AVR mode". During battery operation, the displayed message alternates among the battery mode
messages.
Note 2: The power output is different depending on the operating condition.