Omnitracs MCP100, Руководство по установке

Страница: 47 / 256

80-J4866-2 Rev. G
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION
4-5
Installation Planning Conventional Vehicle Types
Freightliner FLD
• MAS — Install on side wall or hang under bunk.
- Install so there is always SD card slot access.
• MDU — Attach to electrical access panel behind gearshift.
• Cables — Route externally.
- Cables exit/enter sleeper near MAS.
- Cables enter/exit cab low on passenger side firewall.
- Drill a 1-1/2" hole for SDM cable.
Freightliner Century/Columbia
• MAS — Install on side wall or hang under bunk.
- Install so there is always SD card slot access.
• MDU — Install on dash where space allows/customer
preference.
• Cables — Route internally.
- Power is at A pillar on passenger side.
- Drill a 1-1/2" hole for SDM cable.
Kenworth T600/W900
• MAS — Install on side wall or hang under the bunk.
- Install so there is always SD card slot access.
• MDU — Install on face of mapbox.
• Cables — Route externally.
- Connect power cable to key switch.
- Cables exit/enter sleeper floor near MAS.
- Cables enter/exit cab through firewall high on driver side. Look for rubber plugs.
- Drill a 1-1/2" hole in floor of side box for SDM cable. A hole already exists in the firewall.
Kenworth T2000
• MAS — Install on side wall or hang under the bunk.
- Install so there is always SD card slot access.
• MDU — Install on passenger side glovebox.
• Cables — Route externally.
- Connect power cable to key switch.
- Cables exit/enter sleeper floor near MAS.
Display
Electrical
Panel
Antenna cable
access hole
MAS
Freightliner
Existing
heater
box
A pillar
Display
Electrical
Panel
Antenna cable
access hole
MAS
Freightliner
Existing
heater
box
A pillar
Kenworth
Display-
face of
map box
Power-
key switch MAS
Antenna
cable
access
hole
Kenworth
Display-
face of
map box
Power-
key switch MAS
Antenna
cable
access
hole