Omnitracs MCP100, Руководство по установке, Страница: 55 / 256

80-J4866-2 Rev. G
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION
5-5
Mobile Application Server (MAS) Installation Securing the MAS
Securing the MAS
• Tighten the four self-drilling screws into the mounting surface with a Torx #25 driver.
Installing the Power Cable
Low Voltage Disconnects (LVDs)
An LVD is circuitry in some trucks that remove “non-critical” loads, such as TVs, radios, and
microwaves from the truck battery when operating these items without the vehicle running.
This ensures that there will be enough battery power left to start and run the vehicle.
Do not wire the MCP100 through any LVD device as this will affect the normal operation of
the system. When the LVD is engaged:
- MCP100 will not transmit or receive messages
- Panic button will not operate
- Tamper detection will not work
- Vehicle position will be lost
- Backup battery life will be significantly reduced
Power Cable Run
• Run direction — Route the power cable from the MAS to the power connection points.
• Routing location — Route internally or externally. If routed externally, use the supplied
convoluted tubing.
• Cable dressing — Store and secure excess cable.
Power Cable Routing
1. Select one of the following electrical power interface locations on the vehicle:
• Key switch
• Fuse panel
• Bus bar
• Circuit breakers
2. If needed, temporarily remove the two fuses from the fuse holders on the end of the
cable.
3. Route the fuse end of the power cable from the MAS location into the cab of the vehicle.
4. Re-install the fuses onto the appropriate wires.
5. Power on the MAS when ready. Powering up the MAS should be the last step of the
installation.