Omnitracs MCP100, Руководство по установке

Страница: 114 / 256

Config Screen System Verification
12-8
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION
80-J4866-2 Rev. G
Field Description
Powerdown • Number of minutes after ignition is turned OFF when the MCP100
will go into sleep mode.
• Configured by dispatch.
Wakeup • The frequency the MCP100 wakes up from sleep mode to check
for dispatch messages.
• Configured by dispatch.
Total Time • Number of minutes the MCP100 draws power from the vehicle
battery with the ignition OFF.
• Configured by dispatch.
Time Remaining Number of minutes before the MCP100 goes into sleep mode.
Motion/screen
Blanking • Indicates if the display screen will be active when motion is
detected (shown as Disabled or BlankEntireScreen).
• Configured by dispatch.
Ign ON MIPRs Indicates if a mobile-initiated position report will be sent when ignition
is turned ON.
BOT/EOT MIPRs Indicates if beginning of trip and end of trip mobile-initiated position
reports will be sent.
MIPR Freq Indicates the frequency (
HH
:
MM
:
SS
) of mobile-initiated position
reports.
Panic Indicates whether the panic button notification feature is enabled.
Panic Voice Indicates if an audio message will be played (TTS) when a panic
button press is detected.
Stealth Indicates whether panic notifications will show in the messaging
Outbox.
Panic Config Indicates how hardware needs to be connected for panic button
presses to be detected.
Tamper Detect Indicates if the MCP100 is enabled or disabled for tamper detection.