Safety Accessories Supplementary Sheet
24
OMICRON
SAFETY OUT
connector of the control unit. Test the functionality of the
SAA2
system after each start of the
main device, before performing measurements as described later in this chapter.
NOTE!
If you disconnect the
SAA2
from the main device, the test system will only work if you plug in the
Safety Connector Dongle
into the
SAFETY
output connector of the main device.
Figure 6: Front view of the
SAA2
NOTE!
Back view of the
SAA2
. Unused channel connector (CH 1 or CH 2) must be terminated by inserting a
SAA2
dongle into the
unused CH connector.
Figure 7: Rear view of the
SAA2
Connect to the
SAFETY
output connector of the main device
Power input 24 V DC
INTEGRATED BEEPER
LIGHT
LIGHT INTENSITY
ON / OFF
CONTINOUS / FLASHING
HIGH / LOW
Connect to the
SAFETY INPUT
of an additional cascaded
Safety Accessory
OR
connect the
Safety Connector Dongle
of the main device to this connector
Signal lamp Channel 1
Signal lamp Channel 2
