Safety Accessories Supplementary Sheet
18
OMICRON
4.3
Connection
1. Make sure that the main device intended to be used with the
SAA1
is switched off.
2. Press the
Emergency Stop
button on the main device or the test system (on
VOTANO 100
the
Emergency Stop
button on the
SAB1
safety box) and lock the main device with a physical key
(
CPC 80
and
CPC 100
)
or by pressing the software lock button (
TESTRANO 600
and
VOTANO 100
).
NOTE!
CIBANO 500
and
COMPANO 100
do not have a separate physical key nor a software lock
function.
3. Remove the
Safety Connector Dongle
from the
SAFETY
output on the main device’s side panel
(does not apply to
VOTANO 100
which does not have this dongle).
4. Plug the
SAA1
in the
SAFETY
output and connect the
Safety Connector Dongle
to the
SAFETY
output of the
SAA1
or connect any other compatible OMICRON
Safety Accessory
to the
SAA1
SAFETY
output connector. In case of
VOTANO 100
connect the
SAB1
to
SAA1
SAFETY
output
connector.
Figure 3: Fixing the
SAA1
Beeper Dongle and the
Safety Connector Dongle
(example main device: CPC 80/100)
5. Fix the
SAA1
Beeper Dongle and the
Safety Connector Dongle
by turning the locking wheel on both
sides of the
SAA1
Beeper Dongle and fastening the locking screws on the
Safety Connector Dongle
.
WARNING
Death or severe injury caused by high voltage or current possible.
Do not remove the
SAA1
while the test system's outputs are activated.
Removal of the
SAA1
will cause the outputs to be disabled immediately,
which can lead to dangerous voltage spikes.
Locking wheels
MAIN DEVICE
SAFETY OUTPUT
Locking screws
SAA1
SAFETY OUTPUT
MAIN DEVICE
SAFETY CONNECTOR DONGLE
SAA1
TEST BUTTON
