Omicron SAA1, Дополнительный лист

Страница: 10 / 48

Safety Accessories Supplementary Sheet
10 OMICRON
2
Compatibility with OMICRON test systems
The aim of the
Safety Accessories
described in this document is to increase the safety during operation of
OMICRON test systems. Use the
Safety Accessories
ONLY with compatible main devices of test systems
and their accessories. Using other main devices of other test systems may impair the protection and
functionalities provided by the Safety Accessory . Table 2 gives an overview about the compatibility of the
Safety Accessories
with OMICRON main devices/test systems.
Table 2: Compatibility with OMICRON main devices (marked with a “+”)
SAA1 SAA2 SAA3 SAB1 1 CP Strobe 2
CIBANO 500
   — 
COMPANO 100 —
 
— —
CPC 80/100
  
—

TESTRANO 600
  
—

VOTANO 100
 
—

—
Some of the main devices listed above in Table 2 have only one SAFETY output, while some have two
SAFETY outputs:
Main devices with one (1) SAFETY output connector
• COMPANO 100
• CPC 80 / CPC 100
• VOTANO 100 with VBO2
Main devices with two (2) SAFETY output connectors
• CIBANO 500
• TESTRANO 600
The SAFETY output connector locations for each main device are shown in Table 3 on the following page.
NOTE! We recommend cascading only a maximum of two
Safety Accessories
per SAFETY output for
CIBANO 500
and
TESTRANO 600
.
NOTE!
If cascading SAA2 with any other Safety Accessory using the
SAFETY
output connectors of
CIBANO 500 or TESTRANO 600 , cascade the SAA2 only with a Safety Accessory connected to
SAFETY 1 connector of the
CIBANO 500
or
TESTRANO 600
.
1
SAB1 is only to be used with and compatible with VOTANO 100 . For more information and documentation on SAB1 please see
VOTANO 100 Getting Started and VOTANO 100 User Manual.
2
CP Strobe
is discontinued and replaced by the
SAA2
.