9) 1 Red Flash / Pause = System was triggered by current sensing.
10) 2 Red Flashes / Pause = System was triggered by an open hood or trunk.
11) 3 Red Flashes / Pause = System was triggered by an open door.
12) 4 Red Flashes / Pause = System was triggered by the sensor.
Note: Turning on the ignition will clear the Alarm Condition Memory Recall.
Starting System Status:
The primary function of the Status Indicator
Light is to indicate the status of the security system:
13) Off = The remote starter system is off and in standby mode. The security
system is disarmed and not performing automatic functions.
14) Flashing Slow Green = The engine is running after remote starting.
15) Flashing Fast Green = A remote start command has been received, and
the system is in the process of starting the engine.
Remote Starting Diagnostics:
Whenever the system is placed into
Easy Valet Mode, the Status Indicator Light illuminates solid Red. However,
when this occurs, the Status Indicator Light will flash Red, then 1 to 6 Green
flashes before resuming solid Red. This indicates why the engine stopped
running from the last previous remote starting.
16) Red / 1 Green Flash / Red = Programmed run time expired.
17) Red / 2 Green Flashes / Red = Brake was pressed or hood opened.
18) Red / 3 Green Flashes / Red = Engine stalled or bad tach signal.
19) Red / 4 Green Flashes / Red = Received transmitter command to stop.
20) Red / 5 Green Flashes / Red = Gear selector removed from “park”.
21) Red / 6 Green Flashes / Red = Security system triggered or low voltage.
Combination Indications:
These indications occur when security and
remote starting operations are, or have been, simultaneous.
22) Slowly Alternates Red & Green = Full Valet Mode (page 19).
23) Solid Green w/ Red Flash = Security Armed with Starting Valet Mode.
24) Solid Red w/ Green Flash = Remote starter system engaged with security
system in Easy Valet Mode.
25) Rapidly Alternates Red & Green = Remote starter system engaged with
security system armed.
26) Slow Flashing Green w/ 1 to 4 Red Flashes = This indication is during
remote start operation after disarming the alarm, and shows that the
previously Armed alarm was Activated, or triggered, and reset prior to the
remote starting. The Red flashes are the Alarm Condition Memory Recall,
explained on the previous page, occurring with the “engine running”
indicator.
Page 21
