Press & Release the “Arm/Lock” Button ( ) and the “Disarm/Unlock”
Button ( ) together
THE PARKING LIGHTS
WILL ILLUMINATE*
To Activate Remote Starting:
AND
J
THE ENGINE
STARTS
U
The remote starting operation is as follows:
1) Press and release the transmitter’s “Arm/Lock” and “Disarm/Unlock”
buttons. The system will respond first by rapidly flashing the Status
Indicator Light Green, then by turning on the ignition and flashing the
parking lights once.
2) The starter will engage until the engine runs; 10 seconds later the parking
lights will illuminate steady during the period that the engine is running
from being remotely started. (having them flash instead is an option).
The engine will run for 10 minutes (the factory-set period). A 20 minute
setting may be programmed, if desired, by referring to the “Programming
Features” section. Once the engine has been remotely started, to remotely
stop the engine again press and release together the transmitter’s “Arm/
Lock” and “Disarm/Unlock” buttons. The system will stop the engine, and
extinguish the parking lights.
-
When leaving the vehicle before remote starting, remember to
“Preactivate” the system for remote starting (see next page) and also to
set the climate controls to the desired heating or air conditioning settings.
-
If desired, the system’s alarm function may be armed or disarmed as
needed during remote start operations (the system must be disarmed
before entering the vehicle).
Should the engine fail to start on the first attempt, the system will
subsequently make as many as three further attempts, if needed. Please note
that each starting attempt takes approximately 20 seconds for the system to
check the vehicle’s status, cycle the ignition and starter circuits, and then
monitor vehicle status again before the next attempt.
Page 16
* FLASHING PARKING
LIGHTS IS OPTIONAL
