400715D-EN
10
Mixing Tube
Mixing tubes vary on equipment. The
fusible mixing tube
[2] is required on the A-Jet.
Figure 5
[1] Mixing tube [2] Fusible mixing tube
INSTALL THE NOZZLE
NOTICE
To avoid damage to high-pressure components (such as lines, tubing, nipples, gland nuts, safety valves,
nozzle, inlet body) use two wrenches to counteract the torque when adjusting, attaching, or removing high-
pressure components. Binding and twisting of the high-pressure components may cause leaks and water
damage.
n
Install the Nozzle Body on an A-Jet
.
n
To install on a Motorized Z-Axis, go to
Install the Nozzle Body on a Motorized Z-Axis
.
n
To install on a Tilt-A-Jet, go to
Install the Nozzle Body on a Tilt-A-Jet
Install the Nozzle Body on an A-Jet
WARNING
Do not install or remove the nozzle while the A-Jet motor on or active. Severe injury and damage to the A-
Jet may occur. Make sure the primary power, water, and air sources are turned off. Follow the lockout and
tagout procedures to notify others maintenance is in progress.
NOTICE
Remove the mixing tube BEFORE installing or removing the nozzle to prevent damage. Large upward
forces from an installed mixing tube can misalign the internal nozzle components.
1.
Remove the
mixing tube
if it is installed in the
nozzle body
NOTICE
Handle the nozzle carefully to prevent damage to the abrasive tubing retention tube.
Содержание MAXJET 5i 305617 Series
Страница 32: ...32 400715D EN...