Omax MAXJET 5i 305617 Series, Руководство по установке и обслуживанию

Страница: 18 / 32

400715D-EN
18
4. Hold the nozzle body to counteract the torque, then torque the mixing tube nut to secure the mixing tube .
Figure 26
REMOVE THE NOZZLE
NOTICE
To avoid damage to high-pressure components (such as lines, tubing, nipples, gland nuts, safety valves,
nozzle, inlet body) use two wrenches to counteract the torque when adjusting, attaching, or removing high-
pressure components. Binding and twisting of the high-pressure components may cause leaks and water
damage.
When removing the nozzle assembly, first Remove the Mixing Tube , then remove the nozzle body.
n
To remove on an A-Jet, go to Remove the Nozzle Body from an A-Jet .
n
To remove on a Motorized Z-Axis, go to Remove the Nozzle Body from a Motorized Z-Axis .
n
To remove on a Tilt-A-Jet, go to Remove the Nozzle Body from a Tilt-A-Jet .
Remove the Mixing Tube
NOTICE
Remove the mixing tube BEFORE installing or removing the nozzle to prevent damage. Large upward
forces from an installed mixing tube can misalign the internal nozzle components.
1. Hold the nozzle body to counteract the torque and loosen the mixing tube nut .
Figure 27