23
400715D-EN
Maintenance Schedule
Use the following maintenance activities and schedule to develop a successful equipment maintenance program.
Reference documents and videos provide instructions for performing the specific task.
NOTE
• The expected life of components varies based on specific use cases and environmental conditions.
• The hours listed in this schedule for recommended maintenance are NOT warranty hours.
• The filter assembly and mixing tube vary with equipment.
OMAX MAXJET 5i Nozzle Maintenance
MAXIEM MAXJET 5i Nozzle Maintenance
.
Task
Frequency
Reference
Nozzle Body
Clean the nozzle body to prevent mineral buildup in
the jewel assembly
Every 40 hours
Clean and Examine the
Nozzle Body
Replace the nozzle body
Every 500 hours or when cutting
performance degrades
Remove the Nozzle
Install the Nozzle
Mixing Tube
Rotate the nozzle mixing tube 90 degrees (one-
quarter turn) to even out the wear
Every 8 hours of cutting
Clean or replace the mixing tube
As needed
Remove the Mixing Tube
Install the Mixing Tube
Filters and seals
Replace the final filter assembly (plastic)
Every 40 hours, or more frequently
as needed
Replace the Final Filter
Assembly
Clean the metal filter screen
Every 40 hours, or more frequently
as needed
Clean the Metal Screen
Filter Assembly
Examine the ring seal assembly for damage
Replace as needed
Clean the Metal Screen
Filter Assembly
Abrasive Tube
Examine the abrasive tubing (hopper to nozzle)
Daily, replace as needed
Do an Inspection of the
Abrasive Feed Tube
Prepare For Maintenance
CAUTION
Before performing service on the equipment, turn the air supply to the system OFF and bleed the entire
pneumatic system to make sure it is exhausted of air pressure, including any accessories. Failure to
release the pressure may result in injury.
Содержание MAXJET 5i 305617 Series
Страница 32: ...32 400715D EN...