Omax MAXJET 5i 305617 Series, Руководство по установке и обслуживанию

Страница: 29 / 32

29
400715D-EN
6. Install the nozzle body . See Install the Nozzle Body .
Clean and Examine the Nozzle Assembly
Clean the nozzle assembly once a week, or more frequently if needed, to keep the orifice assembly free of mineral
buildup that degrades cutting performance. A clean orifice assembly also helps to prolong the life of the mixing tube.
NOTICE
Handle the nozzle carefully to prevent damage to the abrasive tubing retention tube.
1. Remove the mixing tube . See Remove the Mixing Tube .
2. Remove the nozzle body.
• For the A-Jet, go to Remove the Nozzle Body from an A-Jet .
• For the Motorized Z-Axis, go to Remove the Nozzle Body from a Motorized Z-Axis .
• For the Tilt-A-Jet, go to Remove the Nozzle Body from a Tilt-A-Jet .
3. Fill an ultrasonic cleaner with white vinegar.
4. Remove the mixing tube collet [1], collet O-ring [2], and mixing tube nut [3].
Figure 51
5. Remove the O-rings from the nozzle body .
Figure 1
6. Put the nozzle body , mixing tube , mixing tube nut , and collet in the ultrasonic cleaner for 3—5 minutes or
until the jewel orifice is clean.