Olympus IPLEX FX IV8000-2, Инструкция по эксплуатации, Страница: 157 / 208

149
Chapter 6 Measurement procedures
Profile
This mode allows for displaying the surface profile obtained by sectioning the
target object with a plane defined by the line connecting two specified points and
the optical center axis. The image on the left shows the contours of the line that
connects the two points. The surface profile graphics overlaid on the right screen
shows the profile viewed from the direction that is perpendicular to the Z-axis.
The graph shows the result of observation from a direction, from which the
reference line on the profile image looks the longest.
Specifying and moving the measurement points
To move the cursor, tilt the [MEAS/ENTER] joystick in the desired direction.
Then, press the [MEAS/ENTER] joystick to specify the required number of
measurement points for each measurement mode in the input area for the left
image on the left side of the screen.
When the measurement mode is distance, point to line, offset, or depth, the
measurement results and the object distance measured at the cursor (distance
between the distal end of the adapter and the subject) are displayed.
If the measurement mode is area/lines or multi, the object distance measured at
the cursor is displayed. The measurement results are displayed by specifying the
measurement point.
In addition, the measurement result displaying “–. – – – mm”, indicates that the
correct reference point was not automatically acquired.
Profile