Olivetti ECR 5000, Инструкция по эксплуатации

Страница: 26 / 64

19
ENGLISH
Setting a Percent Discount (-%) Rate
Proceed as follows to define a standard discount rate:
1. Slide the control switch to the PRG position.
2. Type the [numbers] representing the desired percentage rate. Up to
four digits ranging from 0 to 99.99 can be used, and you MUST enter
a total of four digits, two before and two after the desired decimal
place. For example, to enter 10%, type
[1000], to enter 6.5% type
[0650] .
3. Press the
[-%]
key to store the rate.
4. Program another feature or exit program mode by sliding the control
switch to the OFF position.
Example:
Program a standard 10% discount rate.
Type/Press:
[1000] + [-%]
Decimal Point Position
The decimal point setting is preset to the x.xx format. This format can be
changed, as needed, to one of the other settings below.
Changing the Decimal Point Position
Proceed as follows to define a new position for the decimal point.
1. Slide the control switch to the PRG position.
2. Type
[1]
followed by the status number
[0, 1, 2 or 3]
to select the
desired format as indicated in the following table:
Status Number Format
0 x
1 x.x
2 x.xx
3 x.xxx
3. Press the
[RA/ ]
key to set the new format.
4. Program another feature or exit program mode by sliding the control
switch to the OFF position.
Example: Program the cash register so that two digits are left after the
decimal point.
Type/Press:
[1] + [2] + [RA/ ]
Value Added Tax (VAT) Rates
Up to four VAT rates (VAT 1, VAT 2, VAT 3 and VAT 4) can be preset
in the cash register. A maximum 5-digit VAT rate can be programmed (0-
99.999%).
Setting a Fixed VAT Rate
Proceed as follows to program a fixed tax rate:
1. Slide the control switch to the PRG position.
2. Type the
[number]
that represents the VAT (1 for VAT 1, 2 for
VAT 2, 3 for VAT 3 and 4 for VAT 4).
3. Press the
[VAT]
key.
4. Type the VAT rate. Up to five digits can be used, and you MUST enter
three digits after the desired decimal place. For example, to enter a
5.5% VAT rate, type
[5500] ; to enter a 16% VAT rate, type [16000] .
5. Press the
[Amt Tend/TOTAL]
key.
NOTE: If you make an error, press the [C] key and start again from
step 2.