Olivetti 3D IoT, Руководство пользователя, Страница: 6 / 77

vi User Manual 596806-02
TRANSPORTATION AND INSTALLATION:
At least two persons are requested for transporting the 3D printer. The weight of the printer with packing is
approximately 31 Kg.
Personnel charged with handling the shipment must wear safety gloves.
When lifting or moving the 3D printer, or any of its parts, first make sure that the operating area is completely
clear, leaving also a sufficiently large safety area around it to avoid damaging persons or objects that could come
within the area for manoeuvring the load.
Note:
conserve the original product packaging in case you will need it for shipping the product in the future.
Observe the following instructions:

the printer must be placed on a flat stable surface (not supplied with the printer) of sufficient load-bearing
capacity to support its weight, and at a minimum floor height of 60 cm.

fans are provided for cooling the electronic parts. Make sure there is sufficient free space around the printer
to allow adequate air circulation for ventilation. You must leave a distance of at least 60 cm from walls or
other objects.

do not position the printer near sources of heat, water or other freely moving liquids.

do not expose the printer to dust, rain, humidity or vapour.

the operating environment temperature must be maintained at 20°C approximately.

by law the equipment must be grounded; use exclusively the power cord provided with the product without
extension cords.

to protect the printer during transportation, the print carriage is locked into position with strapping tape: before
starting to print cut and remove this tape.
USE

The 3D IoT printer is not suitable for use by persons under 14 years of age, and anyway always under the
direct supervision of an adult. Make sure that children do not tamper or play with the equipment.

The printer is intended for use by operators who have received adequate training.

Use the power supply voltage indicated in the technical specifications. The power cord must never be pulled,
subjected to weights or brought into contact with sharp objects.

Do not touch the equipment with parts of the body that are wet; footwear must always be worn.

Do not smoke, use naked flames or create sparks in the vicinity of the printer.

If the printer malfunctions or fails, do not attempt to use it again until it has been repaired.

When the 3D IoT printer is functioning, certain parts generate high temperatures (printhead, heated table if
present); there are also moving parts which could cause injury if touched accidentally during operation. You
must therefore observe the following warnings carefully:

Whenever any operation is carried out on the printer - whether for installation or maintenance purposes
- always first switch off and disconnect the equipment from the electrical socket. Before proceeding,
wait for all parts that may have become heated during the previous operation to cool down.

The machine must be used exclusively with the front door closed ; printing IS NOT interrupted
automatically when the front door is opened, therefore this instruction must be observed with maximum
attention.

The front door is fitted with a lock and key to prevent unauthorised access.

The key must be conserved in a safe place by those responsible for its safe-keeping.