Olivetti 3D IoT, Руководство пользователя, Страница: 34 / 77

2-14 User Manual 596806-02

DISTANCE (mm): 100.

SPEED (mm/sec): 500

ACCELERATION (mm/sec
2
): 12
IV. Press the RIGHT arrow on the Z row to lower the table:
Figure 2-21 Move command for Z axis
2.
when the table has completed its movement, remove the four clamps by pressing lightly on their metal
wings.
3.
after removing the clamps, lift the glass table, reverse it and place it gently on a flat surface.
4.
spray on the glass the lacquer (strong/extra strong hold) from a distance of approximately 15 cm. The
best procedure is to spray across the table first horizontally and then perpendicularly. Be sure to carry
out this operation in a well ventilated room, far from inflammable objects and other objects that could
become covered with lacquer.
5.
wait a few seconds until the lacquer dries (it is dry when no fingerprints are left) and proceed to remount
the table fixing it again with the four clamps.
To resume printing on the PEI surface, repeat the removal operation of the plate described above, clean the
glass surface removing the lacquer residues (using a degreaser) and replace the plate with the PEI surface
facing up.
WARNING: Although the glass is hardened it is still fragile, so you must always be very careful when
handling it.