Olivetti 3D IoT, Руководство пользователя, Страница: 40 / 77

3-6 User Manual 596806-02
Figure 3-6
“Resume Saved Job”, with Restart command

now select the
“
Restart
” command. The printer begins to extrude slowly, filling the nozzle to
the appropriate level.
During this phase, the screen below is shown on the display (Figure 3-7). Check that the
printer is extruding in a regular manner then
confirm the restart operation by selecting
“
Restart
”.
To avoid imperfections in the printed object, you are advised to remove by hand the filament
that is extruded during the restart phase, that is before the nozzle and table come into contact
again. For this operation
you must always wear protective heat-resistant gloves and pay
maximum attention to the nozzle, avoiding all contact with it.
Figure 3-7
“Pause” Screen showing Restart command
c. the third option in the
“Pause” screen is
Change Filament that is activated by selecting
“
Ch Filam
”.
When this command is selected, the following screen appears on the display:
Figure 3-8
“Change Filament” screen