Olivetti 3D IoT, Руководство пользователя, Страница: 35 / 77

596806-02 User Manual 3-1
Chapter 3 –
PRINTING WITH THE OLIVETTI 3D IOT
PRINTING WITH THE OLIVETTI 3D IOT PRINTER
After you have carried out the printer adjustments and loaded the bobbin with the filament, the printer is ready
to use.
Printing a test piece
On the SD card in the kit, you can find some files that can be used for executing a printing test to gain confidence
with using the printer.
WARNING: if the SD Card cannot be recognised / read, check the position of the lock switch on the
side of the card, making sure it is in the unlocked position (that is, enabled for reading and writing).
To print a test piece:
1. Insert the SD CARD into the slot at the front of the printer
2. Starting from the Desktop Menu, press the Menu key and then, in the next screen, the SD key
Figure 3-1 From the Desktop Menu, select Menu then SD
3.
Select the file to print (e.g. Logoolivetti1.gcode)
4.
The machine now starts the automatic printing procedure reading the GCODE file indicated, executing all
phases. You can follow the process from either the Info menu or, naturally, looking through transparent
door of the printer.
When printing is launched, the printer executes the following procedure:
1. Homes all axes,
2. Heats the extruder and table, until the temperature required is reached
3. Extrudes a small quantity of material for loading into the extrusion chamber
4. Moves to the printing area, and starts the procedure for printing layer on layer.
5. When printing completes, the machine sends the carriage to the Home position. It then switches off the
heaters to allow the machine to return to the normal environmental temperature.
NOTE:
Files in the printing format supported by the Olivetti 3D IoT printer always have the
extension .GCODE.