Oliver LEGACY ELITE 2022, Руководство пользователя

Страница: 284 / 410

284
TRUMA ELECTRIC ANTIFREEZE KIT
5
Installation instructions
You will find more information about the
following in the operating instructions for
the Truma AquaGo™ instant water heater:
• Operation
• Access door
• Draining the water
Preparing for installation
1. Remove the access door.
2. Switch OFF the Truma AquaGo™ instant
water heater at the POWER switch and at the
control panel (set Operating mode to OFF).
Installing the holder
3. Attach the holder to the rear side of the ac-
cess door, as shown in Figure 2.
• Undo the two screws of the webbing
about 1/10 inch (2.5 mm).
• Position the holder below the screws.
• Tighten the screws.
Screws
Holder
Holder
Webbing
Access
door
Fig. 2
6
4. Clamp the plug beneath the holder, as
shown in Figure 3.
Holder
Plug
Lug
Access
door
Fig. 3
Installing the heating cartridge
1. Turn OFF the water supply or switch OFF the
water pump.
2. Open a hot water faucet and leave it open in or-
der to depressurize and vent the water system.
3. Injuries caused by the
Easy Drain Lever!
When the Easy Drain
Lever is folded out, it protrudes beyond the
side wall of the vehicle.
• When walking past or bending over,
make sure that you and others have suf-
ficient distance.
4. Open the latch with your thumb while pulling
the Easy Drain Lever down as far as it will go.
5. Remove the water inlet filter as shown in
Fig. 4a and rinse it with clean water.
Keep the water inlet filter in a safe place.
When you decalcify the Truma AquaGo™
instant water heater, you will need it for the
Truma AquaGo™ decalcification tablets.
6. Inspect the O-rings on the heating cartridge
for cracks. Replace the heating cartridge if
there are cracks.