Oliver LEGACY ELITE 2022, Руководство пользователя

Страница: 102 / 410

102
CRADLEPOINT WIRELESS WAN
©2017 Cradlepoint. All Rights Reserved. | +1.855.813.3385 | cradlepoint.com 65
User Manual / IBR900/IBR950 1/5/17
• Offset list in: Offset-list adds the specified offset
to the incoming and outgoing metric for routes
matched by the specified access-list. If the offset
is 0, no action is taken.
• Offset list out: Offset-list adds the specified
offset to the incoming and outgoing metric for
routes matched by the specified access-list. If
the offset is 0, no action is taken.
Networks : Set the RIP-enabled interfaces by
network. RIP is enabled on the interfaces that have addresses within the network range.
Interfaces: Enable RIP on a specific interface. Useful if the interface’s IP addresses are dynamic.
• Device: Select network interface device.
• Send version: Select the RIP version that will be sent on this interface, overriding the global setting.
Version can be 1 or 2, or 0 to select both.
• Receive version: Select the RIP version that will be accepted on this interface, overriding the global
setting. Version can be 1 or 2, or 0 to select both.
• Passive: Select passive mode for the interface. In passive mode, RIP routing updates are accepted by, but
not sent out of, the interface.
• No split horizon: Disable the split horizon mechanism. Enabling prevents RIP from advertising routes over
the interface on which they were learned.
• Distribute Access-list In/Out: Specify access-lists that filter the incoming and outgoing distribution of RIP
routes.
• Distribute Prefix-list In/Out: Specify prefix-lists that filter the incoming and outgoing distribution of RIP
routes.
Neighbors : When a neighbor doesn’t understand multicast, this command is used to specify neighbors. In some
cases, not all routers will be able to understand multicasting, where packets are sent to a network or a group
of addresses. In a situation where a neighbor cannot process multicast packets, it is necessary to establish a
direct link between routers. The neighbor command allows the network administrator to specify a router as a
RIP neighbor. The no neighbor a.b.c.d command will disable the RIP neighbor. Assign a neighbor by inputting an
IP address.
Redistribute Routes : Redistribute routes of the specified protocol or kind into RIP, with the metric type and
metric set (if specified), filtering the routes using the given route map (if specified). Redistributed routes may
also be filtered with distribute lists.
• Type : The type is the source of the route. Select from: Main, Connected, Static, OSPF, BGP.
• Metric : RIP metric is a value for distance for the network. Usually RIP increments the metric when the
network information is received. The metric for redistributed routes is set to 1.
• Route Map : Route maps provide a means to filter and/or apply actions to routes, allowing policies to be
applied to routes.
RIP ng
RIPng (RIP next generation) extends RIPv2 to support IPv6. See RIPng on Wikipedia and RFC 2080 for details.
RIPng Editor
• Name : Unique name of the policy.