Oliver LEGACY ELITE 2022, Руководство пользователя

Страница: 180 / 410

180
LITHIONICS LITHIUM BATTERIES
LITHIONICS BATTERY, CLEARWATER, FL 33765 USA
PH: 727.726.4204 | FAX: 727.797.8046 | WEB: LITHIONICSBATTERY.COM
Page 6 of 11
Power Button with Status Light
The BMS power button is located on the battery lid and includes a status light. You can also attach
the optional remote power button (Lithionics Part # 75-224-196) via the panel mount connector. This
can be useful if the battery is installed in a location that is not easily accessible. The function and
operation of the remote power button remains the same as the main power button on the battery.
Refer to the table below for an explanation of the power button status light blink patterns.
Battery State Status Light
Powered On Solid ON
Powered Off Solid OFF
Charging Slow blink
Low Battery Short blink
Fault Alarm Rapid blink
Status Light pattern over time
< 1 second > < 1 second > < 1 second > < 1 second >
Maintenance and Storage
Maintenance For optimal performance when in use, the battery should be fully charged to 14.4V at least once every 2 weeks.
Fully charging the battery calibrates the state-of-charge percentage to be the most accurate and allows the cells to balance if
necessary.
Storage Storing your battery at the correct specifications is important as it keeps the battery in the healthiest state possible.
Consult the table below for proper storage conditions.
Storage Temperature & Humidity Range < 1 Month -4~95°F (-20~35°C), 45~75%RH
< 3 Months 14~86°F (-10~30°C), 45~75%RH
Long Term Storage If the battery needs to be stored for > 3 months the voltage should be 13.2V
(50% state-of-charge) and stored at the recommended storage specifications
shown above. Additionally, the battery needs at least one charge & discharge
cycle every six months.
Self-Discharge Rate ≤3% per month
Typical storage example < 1 month:
1. Fully charge the battery.
2. Turn the battery
OFF using the battery power button.
3. Keep the battery in an environment according to the specifications shown above.
Typical storage example > 1 month, up to 6 months maximum:
1. Reduce the battery state-of-charge to 13.2V which is 50% ±10% state-of-charge.
2. Turn the battery
OFF via the BMS power button.
3. Keep the battery in an environment according to the specifications shown above.
4. Every 6 months charge the battery to 100% state-of-charge, then discharge the battery to LVC, then charge it back to 50% ±10%
state-of-charge.
Power Button Operation
Power ON Press for 1 Second
Power OFF Press for 3 Seconds
Power Reset
Press for 1 Second (after protection event)