12
.
.
ASSEMBLY TABLE SAW
Warning: Always wear glasses during the
entire setup process.
INSTALL THE TABLE EXTENSION WINGS
Attach the table extension wings to the
main table using 8*12mm hex head bolts
(4 per wing), and 8 lock washers Align the
table extensions with the table and loosely
attach the bolts. Place a straightedge on
the table and extension as shown to align
the extension table and then tighten down
the bolts.
Note: Be sure that the table extension wings
are flush with front edge.
MOUNT FENCE STORAGE BRACKETS
The miter gauge and blade guard storage
brackets are already installed on the saw. Install
the fence storage brackets on the right side of
the saw as shown in using two Phillips head
screws and flat washers.
FRONT RAIL INSTALLED
1. Loosely thread the 3 square head bolts to
the front of the table as below.
2. Do not tighten down the nuts; leave the
square heads of the bolt protruding from the
table
3. From the right side of the saw, slide the
upper slot of the front rail onto the square
head bolts and pull in until pass the saw
blade center.
5. Tighten down the nuts to firmly secure the
front rails to the table.
